Step by Step Guide
How to build your new hybrid bike out of the box
Our bikes are partially disassembled for transport. However, with some helpful tips, you can get your bike ready for riding in just a few simple steps. Here’s our step by step guide!
You need:
- Hex wrenches (4, 5, 6, 8 mm)
- T25 wrench
- Torque wrenches
- Pedal wrench
- Handbook
Step 1: Unboxing
- Remove your bike and all small parts from the box
- Inside the bike box, you’ll find 1-2 small parts boxes
- Remove all packaging from the frame
Step 2: Straighten the bars
- Loosen the bolts on the stem
- Straighten the bars
Step 3: Check the headset for play
- Squeeze the front brake lever
- Move the bike back and forth
- If there’s any play inside the headset, adjust the headset play according to the instructions given in the handbook
Step 4: Align your handlebars
- Twist the handlebars until they are centred
- Tighten the bolts in a crossing pattern, following the instructions you can find in the handbook
Step 5: Adjust the saddle height
- Undo the quick release or bolts on the seat clamp
- Get your seat adjusted properly and follow the maximum and minimum insertion recommendations
- Tighten the quick release lever or bolts on the seat clamp
Step 6: Adjust your grips & accessories
- Loosen the bolts on grips, levers and bell
- Twist the components round the bars to get them into the right position
- Tighten the bolts according to the manufacturer’s instructions
Step 7: Installing the pedals
- Most pedals have a groove around the spindle or a different marker to mark the left and the right pedal
- Place the pedal thread into its side’s crank arm
- Tighten the pedals according to the manufacturer’s instructions